Entering Adhesive Material Maintenance Removal Mode - Epson ML-13000 User Manual

ML-13000 User's Manual
Required Items
Pump
Workflow
1. "Entering Adhesive Material Maintenance Removal Mode" on page 276
2. "Preparing the Felt" on page 277
3. "Setting the felt" on page 280
4. "Ensuring safety" on page 282
5. "Removing ink film" on page 282
6. "Removing and cleaning the felt weight and felt rod" on page 285
7. "After removing the ink film" on page 288

Entering Adhesive Material Maintenance Removal Mode

Switch the printer to maintenance mode.
c
Important:
Normally, you cannot operate the control panel when any cover is open or the belt cleaning unit is pulled out.
Therefore, if you return to the home screen during glue maintenance operations, you will not be able to return to
Maintenance mode until you close the front cover or the belt cleaning unit. Make sure you do not touch the panel
until you are ready, as it may result in performing curing again, setting the jigs again, or failure of glue maintenance
operations.
A
From the Maintenance screen on the control panel, touch Maintenance - Adhesive Material Maintenance.
B
Enter the administrator password.
c
Important:
❏ Change the default administrator password to a new password to ensure that only users who know the
administrator password can switch to maintenance mode. See the following for details on making
changes. The printer and the computer must be connected to the same network when making changes.
"How to Set/Change the User Name and Administrator Password" on page 53
U
❏ Save the password you set in a safe location so that you do not forget it.
See the following if you forget your password.
"If you have forgotten your administrator password" on page 379
U
Maintenance
Quantity Details/Use
1 Commercially available
276
Used when pouring ink film remover into
the bucket. Use a material that does not
dissolve when exposed to organic
solvent.