Removing The Lifter Cable - Canon NP6260 Service Manual

CHAPTER 5 PICK-UP/FEEDING SYSTEM

2. Removing the Lifter Cable

1) Remove the paper deck.
2) Remove the two mounting screws
above, and loosen the two
mounting screws
then, remove the deck front cover
.
3) Remove the two mounting screws
inside the deck, and remove the
front and rear guide plates
4) Mark the position of the latch
assembly; then, remove the left and
right mounting screws
and remove the latch assembly
5) Remove the gear cover
front right.
5-70
COPYRIGHT © 1997 CANON INC.
on the side;
.
(7 in total),
.
from the
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 5-821
Figure 5-822a (left)
Figure 5-822b (right)