Maximum Number Of Operator Positions; Adding A Qcc Operator Position - AT&T MERLIN LEGEND Release 3.1 System Manager's Manual

Adding a QCC Operator Position

Adding a QCC Operator Position
Use this procedure to add a QCC operator position (Hybrid/PBX systems only).
To add a DLC operator position, see the previous section, "Adding a DLC
Operator Position."
Planning Guidelines
QCC operator positions can be assigned only to the first and fifth extension
jacks of an MLX module. The first jack on the first extension module in your
system is automatically assigned as the primary operator position.
A maximum of four QCC operator positions can be assigned.
When other QCC operator positions are added, the primary QCC operator
position should be the first one added.
Any combination of operator positions can be assigned as long as there are no
more than four QCC operator positions and no more than a total of eight
operator positions (see Table 6 9).
Table 6–9. Maximum Number of Operator Positions
Position Type
QCC
DLC
QCC button assignments are automatic and factory-set. In Release 4.0 and later
systems, the Call 5 button is factory set so that Voice Announce is disabled.
The button works the same way as any other Call button. If you use system
programming to enable the Voice Announce feature, the Call 5 button is
available for originating voice-announce calls; the operator does not receive
voice-announced calls on this button.
Lines and trunks are assigned on individual buttons.
6–52
Managing the System
Type of Telephone
MLX-20L
MLX-20L
MLX-28D
BIS-34D, BIS-22, or BIS-22D
analog multiline telephone
MERLIN II Display Console
Maximum Positions
4
8