Starting Centralized Telephone Programming - AT&T MERLIN LEGEND Release 3.1 System Manager's Manual

Centralized Telephone Programming
To perform centralized telephone programming, you can use the system
programming console or a PC with SPM software as described earlier in this
chapter.
If you are programming several telephones of the same type (that is, all analog
or all MLX), you can use the Copy Extension feature (described in "Copying
Feature and SA/ICOM Buttons") to program one extension and then use the
programmed extension as a template for programming additional extensions.
There are special planning forms for the Copy Extension feature.
NOTE:
Some programming can be performed only when the entire system or some part
of it (such as a trunk or an extension) is idle. See "Idle States" earlier in this
chapter.

Starting Centralized Telephone Programming

Reach the Centralized Programming menu from the System Programming menu.
You can then perform centralized telephone programming by selecting features
from the display or by using programming codes.
Follow the procedure below to get to the Centralized Programming menu. For
information about the procedure format, see "Using the Programming
Procedures," earlier in this chapter.
Console/Display Instructions
1 Go to the second screen of the System Programming menu.
2 Select Centralized Programming.
_
Additional Information
Press More.
Managing the System
PC
u
4
6–23