Adding/Removing A Line - AT&T MERLIN LEGEND Release 3.1 System Manager's Manual

Adding/Removing a Line

— Form 5d, Queued Call Console (QCC)
— Data Form 1a, Modem Data Station
— Data Form 1b, 7500B Data Station
If necessary, read "Trunk-to-Trunk Transfers in the Feature Reference for
detailed information about this feature.
Plan changes and record the new values on the form(s).
Open the System Programming menu from the console or a PC with SPM.
Program the change(s), following the instructions for "Trunk-to-Trunk
Transfer" in System Programming , Chapter 3, or the summary
programming instructions below.
When you have finished, file the form(s) with the rest of the planning
forms.
Programming Instructions
Console Procedure:
PC Procedure:
Adding/Removing a Line
Use this procedure to add a line to or remove a line from the system.
Planning Guidelines
If you are adding a new line and need to order a module to connect the line,
coordinate the installation and connection dates to ensure that the new module
is installed before the line is connected to the system.
Task List: Adding/Removing a Line
Obtain Form 2c, System Numbering: Line/Trunk Jacks. Check the form to
confirm that there is a spare jack.
NOTE:
If you are adding a line but there is no spare jack, you need to add a new
module. Contact your AT&T representative.
Contact your central office (CO) to obtain a new line or to disconnect a
line.
More More
Toggle LED On/Off or Dial ext. no.
6 u 7
Toggle letter
0 5
ext. no.
On/Off or Type
5
Managing the System
6–47