AT&T MERLIN LEGEND Release 3.1 System Manager's Manual page 279

Changing Calling Group Assignments
Planning Guidelines
An extension can belong to only one calling group. A QCC cannot be a member
of a calling group. The delay announcement device should not be programmed
as a calling group member.
A calling group can be a Night Service group member.
The total number of extensions can be divided into a maximum of 32 calling
groups. A calling group can include a maximum of 20 extensions, but not all 32
calling groups can have this maximum number.
If a linear hunting pattern is indicated on the back of the system planning form
(7d), be sure to assign extensions to the group in the exact order that they are
shown on the form. The system searches for an available member in the order in
which you assign the extensions to the group.
The Extension Status feature must be set to the calling group or CMS mode
before you assign members to the group. For more information, see "Extension
Status" in the Feature Reference and in the "System Features" section of
Chapter 3, System Programming .
Changing calling group assignments may affect other features; for more
information, see the Feature Reference .
NOTE:
To assign an extension to a new calling group, you must remove it from its old
group before programming the new assignment.
Valid Entries
Extension numbers
Task List: Changing Calling Group Assignments
Obtain Form 7d, Group Calling.
If necessary, read "Group Calling" in the Feature Reference for detailed
information about this feature.
Plan changes using the planning guidelines above; record the new
values on Form 7d.
Open the System Programming menu from the console or a PC with SPM.
Program the change(s), following the instructions for "Group Calling
Member Assignments" in the "Optional Group Features" section of
System Programming , Chapter 3, or the summary programming
instructions below.
When you have finished, file Form 7d with the rest of the planning forms.
6–60
Managing the System