Maximum Number Of Operator Positions; Jacks For Additional Operator Positions - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

Numbering the System
4. Write either the name of the person who will program the system or the
location of the system programming console in the Person, Location, or
Function column. Then proceed to Step 5.
5. Do one of the following:
To indicate the primary QCC operator position for a system with one
or more QCCs, proceed to Step 6.
To indicate the primary DLC operator position for a system with one or
more DLCs, skip to Step 7.
6. To indicate the primary QCC operator position:
a. Locate the first extension jack showing a D (digital) jack type and
write
b. Write the name or location of the primary QCC operator in the Person,
Location, or Function column.
c. On Form 1 (page 2), write the extension of the QCC under System
Consoles.
7. To indicate the primary DLC operator position:
a. Locate the first extension jack showing a jack type of D (digital) or A
(analog) and write
b. Write the name or location of the primary DLC operator in the Person,
Location, or Function column.
c. On Form 1 (page 2), write the extension of the DLC under System
Consoles.
Proceed to the next section, "Jacks for Additional Operator Positions."

Jacks for Additional Operator Positions

Use these instructions only if the system has more than one operator position.
Otherwise, skip to the next section, "Extension Jack Pairs for Analog
Telephones."
The maximum number of operator positions is shown in Table 2–5.
Table 2–5. Maximum Number of Operator Positions
Position
QCC
DLC
DLC
QCC beside the preprinted logical ID number.
DLC
beside the preprinted logical ID number.
Telephone Maximum
MLX-20L
MLX-20L
MLX-28D
Analog multiline
telephones
4
8
8
Control Unit Configuration
2–19