Adding Or Deleting Communities; Snmp Trap And Inform Notifications - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

SNMP Trap and Inform Notifications

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Adding or Deleting Communities

You can configure read-only or read-write access for SNMPv1 and SNMPv2 users. Refer to RFC 2576.
To create an SNMPv1 or SNMPv2c community, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# snmp-server community snmp_Community ro
switch(config)# snmp-server community snmp_Community rw
switch(config)# no snmp-server community snmp_Community
SNMP Trap and Inform Notifications
You can configure the Cisco MDS switch to send notifications to SNMP managers when particular
events occur.
Use the SNMP-TARGET-MIB to obtain more information on the destinations to which notifications are
Note
to be sent either as traps or as informs. Refer to the
This section includes the following topics:
•
•
•
•
•
•
•
Tip The SNMPv1 option is not available with the snmp-server host ip-address informs command.
Cisco MDS 9000 Family CLI Configuration Guide
33-8
Configuring SNMPv2c Notifications, page 33-9
Configuring SNMPv3 Notifications, page 33-10
Enabling SNMP Notifications, page 33-10
Configuring the Notification Target User, page 33-12
Configuring LinkUp/LinkDown Notifications for Switches, page 33-13
Configuring Up/Down SNMP Link-State Traps for Interfaces, page 33-14
Displaying SNMP Security Information, page 33-15
Chapter 33
Purpose
Enters configuration mode.
Adds read-only access for the
specified SNMP community.
Adds read-write access for the
specified SNMP community.
Deletes access for the specified
SNMP community (default).
Cisco MDS 9000 Family MIB Quick
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring SNMP
Reference.