Configuring Ip Services - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs Also See for AP776A - Nexus Converged Network Switch 5020:
Table of Contents

Advertisement

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring IP Services

Cisco MDS 9000 Family switches can route IP traffic between Ethernet and Fibre Channel interfaces.
The IP static routing feature is used to route traffic between VSANs. To do so, each VSAN must be in a
different IP subnetwork. Each Cisco MDS 9000 Family switch provides the following services for
network management systems (NMSs):
Switches are compliant with RFC 2338 standards for Virtual Router Redundancy Protocol (VRRP)
features. VRRP is a restartable application that provides a redundant, alternate path to the gateway
switch.
For information about configuring IPv6, see
Note
Interfaces."
This chapter includes the following sections:
OL-18084-01, Cisco MDS NX-OS Release 4.x
IP forwarding on the out-of-band Ethernet interface (mgmt0) on the front panel of the supervisor
modules.
IP forwarding or in-band Fibre Channel interface using the IP over Fibre Channel (IPFC)
function—IPFC specifies how IP frames can be transported over Fibre Channel using encapsulation
techniques. IP frames are encapsulated into Fibre Channel frames so NMS information can cross the
Fibre Channel network without using an overlay Ethernet network.
IP routing (default routing and static routing)—If your configuration does not need an external
router, you can configure a default route using static routing.
Traffic Management Services, page 44-2
Management Interface Configuration, page 44-2
Default Gateway, page 44-3
IPv4 Default Network Configuration, page 44-4
IPFC, page 44-6
IPv4 Static Routes, page 44-10
Overlay VSANs, page 44-12
Multiple VSAN Configuration, page 44-14
Virtual Router Redundancy Protocol, page 44-16
DNS Server Configuration, page 44-27
Default Settings, page 44-29
C H A P T E R
Chapter 47, "Configuring IPv6 for Gigabit Ethernet
Cisco MDS 9000 Family CLI Configuration Guide
44
44-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents