Enabling Message Throttling Using The Cli; Call Home Enable Function; Enabling Call Home Using The Cli; Call Home Configuration Distribution - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 53 Configuring Call Home
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Enabling Message Throttling Using the CLI

To enable message throttling in a Cisco MDS 9000 Family switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# no
duplicate-message throttle
switch(config-callhome)# duplicate-message
throttle

Call Home Enable Function

Once you have configured the contact information, you must enable the Call Home function.

Enabling Call Home Using the CLI

To enable the Call Home function, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# enable
callhome enabled successfully
switch(config-callhome)#
switch(config-callhome)# disable
switch(config-callhome)#

Call Home Configuration Distribution

You can enable fabric distribution for all Cisco MDS switches in the fabric. When you perform Call
Home configurations, and distribution is enabled, that configuration is distributed to all the switches in
the fabric.
You automatically acquire a fabric-wide lock when you issue the first configuration command after you
enabled distribution in a switch. The Call Home application uses the effective and pending database
model to store or commit the configuration changes. When you commit the configuration changes, the
effective database is overwritten by the configuration changes in the pending database and all the
switches in the fabric receive the same configuration. After making the configuration changes, you can
choose to discard the changes by aborting the changes instead of committing them. In either case, the
lock is released. See
application.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Enters Call Home configuration submode.
Enables the Call Home function.
Disables the Call Home function. When you disable the
Call Home function, all input events are ignored.
Note
Chapter 7, "Using the CFS Infrastructure,"
Purpose
Enters configuration mode.
Enters the Call Home configuration submode.
Disables the duplicate message throttling feature.
Enables the duplicate message throttling feature
(default).
Even if Call Home is disabled, basic information
for each Call Home event is sent.
for more information on the CFS
Cisco MDS 9000 Family CLI Configuration Guide
Call Home Enable Function
53-17