Activating A Manually Configured Ivr Topology - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring IVR
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure a user-defined IVR topology database, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# ivr vsan-topology database
switch(config-ivr-topology-db)#
Step 3
switch(config-ivr-topology-db)# autonomous-fabric-id 1
switch 20:00:00:05:30:01:1b:b8 vsan-ranges 1-2,6
switch(config-ivr-topology-db)# autonomous-fabric-id 1
switch 20:00:00:05:30:01:1b:c2 vsan-ranges 1-3
switch(config-ivr-topology-db)# no autonomous-fabric-id
1 switch 20:00:00:05:30:01:1b:c2 vsan-ranges 1-2
Step 4
switch(config-ivr-topology-db)# end
switch#
View your configured IVR topology using the show ivr vsan-topology command. In the following
example output, VSAN 2 is the transit VSAN between VSANs 1, 5, and 6.
switch# show ivr vsan-topology
AFID
--------------------------------------------------------------
Total:
Current Status: Inter-VSAN topology is INACTIVE
If CFS is not enabled, you must repeat this configuration in all IVR-enabled switches. See the
Note
Merge Guidelines" section on page
Tip Transit VSANs are deduced based on your configuration. The IVR feature does not have an explicit
transit-VSAN configuration.

Activating a Manually Configured IVR Topology

After manually configuring the IVR topology database, you must activate it.
Active IVR topologies cannot be deactivated. You can only switch to IVR topology automatic mode.
Caution
Cisco MDS 9000 Family CLI Configuration Guide
23-20
SWITCH WWN
1 20:00:00:05:30:01:1b:c2 *
1 20:02:00:44:22:00:4a:05
1 20:02:00:44:22:00:4a:07
3 entries in active and configured IVR VSAN-Topology
Active Cfg. VSANS
no yes 1-2
no yes 1-2,6
no yes 2-5
23-36.
Chapter 23 Configuring Inter-VSAN Routing
Purpose
Enters configuration mode.
Enters the VSAN topology database
configuration mode for the IVR
feature.
Configures VSANs 1, 2, and 6 to
participate in IVR for this switch.
Configures VSANs 1, 2 and 3 to
participate in IVR for this switch.
Removes VSANs 1 and 2 from IVR
for this switch.
Reverts to EXEC mode.
OL-18084-01, Cisco MDS NX-OS Release 4.x
"Database