Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 1119

Chapter 43 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch(config-iscsi-init)# static pWWN system-assign 1
switch(config-iscsi-init)# static nWWN system-assign
switch(config)# iscsi initiator ip address 10.15.1.11
switch(config-iscsi-init)# static pwwn system-assigned 1
switch(config-iscsi-init)# vsan 2
Note
Step 8 View the configured WWNs.
Note
switch# show iscsi initiator configured
iSCSI Node name is iqn.1987-05.com.cisco:01.e41695d16b1a
iSCSI Node name is 10.15.1.11
Create a zone with host 1.
Step 9
switch(config)# zone name iscsi-zone-1 vsan 1
Add three members to the zone named iscsi-zone-1.
Step 10
Note
•
•
Create a zone with host 2 and two Fibre Channel targets.
Step 11
Note
switch(config)# zone name iscsi-zone-2 vsan 2
Step 12 Activate the zone set in VSAN 2.
switch(config)# zoneset activate name iscsi-zoneset-v2 vsan 2
Zoneset activation initiated. check zone status
switch# show zoneset active vsan 2
zoneset name iscsi-zoneset-v2 vsan 2
zone name iscsi-zone-2 vsan 2
OL-18084-01, Cisco MDS NX-OS Release 4.x
Host 1 is configured in VSAN 2.
The WWNs are assigned by the system. The initiators are members of different VSANs.
Member of vsans: 1
Node WWN is 20:03:00:0b:fd:44:68:c2
No. of PWWN: 1
Port WWN is 20:02:00:0b:fd:44:68:c2
Member of vsans: 2
No. of PWWN: 1
Port WWN is 20:06:00:0b:fd:44:68:c2
Fibre Channel storage for zone membership for the iSCSI initiator, either the iSCSI symbolic
node name or the pWWN, can be used. In this case, the pWWN is persistent.
The following command is based on the symbolic node name.
switch(config-zone)# member symbolic-nodename iqn.1987-05.com.cisco:01.e41695d16b1a
The following command is based on the persistent pWWN assigned to the initiator. You can obtain
the pWWN from the show iscsi initiator output.
switch(config-zone)# member pwwn 20:02:00:0b:fd:44:68:c2
If the host is in VSAN 2, the Fibre Channel targets and zone must also be in VSAN 2.
iSCSI Authentication Setup Guidelines and Scenarios
<-----------------------------------Host 1
Cisco MDS 9000 Family CLI Configuration Guide
43-75