Displaying Islb Cfs Status; Displaying Islb Cfs Distribution Session Status; Displaying Islb Cfs Merge Status - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
You can display the differences between the pending configuration and the current configuration using
the show islb pending-diff command.
switch# show islb pending-diff
+iscsi initiator idle-timeout 10
islb initiator ip-address 10.1.1.1
+ static pWWN 23:06:00:0c:85:90:3e:82
+islb initiator ip-address 10.1.1.2
+ static nWWN 23:02:00:0c:85:90:3e:82

Displaying iSLB CFS Status

You can display the iSLB CFS status using the show islb session status command.
switch# show islb status
iSLB Distribute is enabled
iSLB CFS Session exists

Displaying iSLB CFS Distribution Session Status

You can display the status of the iSLB CFS distribution session using the show islb cfs-session status
command.
switch# show islb cfs-session status
last action
last action result
last action failure cause : success

Displaying iSLB CFS Merge Status

You can display the iSLB CFS merge status using the show islb merge status command.
switch# show islb merge status
Merge Status: Success
Merge conflicts may occur. User intervention is required for the following merge conflicts:
•
•
•
•
•
Check the syslog for details on merge conflicts.
Tip
User intervention is not required when the same iSLB initiator has a different set of non-conflicting
initiator targets. The merged configuration is the union of all the initiator targets.
Cisco MDS 9000 Family CLI Configuration Guide
43-58
The iSCSI global authentication or iSCSI initiator idle timeout parameters are not configured the
same in the two fabrics.
The same iSLB initiator is configured differently in the two fabrics.
An iSLB initiator in one fabric has the same name as an iSCSI initiator in the other fabric.
Duplicate pWWN/nWWN configuration is detected in the two fabric. For example, a
pWWN/nWWN configured for an iSLB initiator on one fabric is configured for an iSCSI initiator
or a different iSLB initiator in the other fabric.
A VSAN configured for an iSLB initiator in one fabric does not exist in the other fabric.
: fabric distribute enable
: success
Chapter 43 Configuring iSCSI
OL-18084-01, Cisco MDS NX-OS Release 4.x