Rmon Verification; Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

RMON Verification

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
RMON Verification
Use the show rmon and show snmp commands to display configured RMON and SNMP information
(see
Example 50-1 Displays Configured RMON Alarms
switch# show rmon alarms
Alarm 1 is active, owned by admin
Monitors 1.3.6.1.2.1.2.2.1.16.16777216 every 1 second(s)
Taking delta samples, last value was 0
Rising threshold is 1, assigned to event 0
Falling threshold is 0, assigned to event 0
On startup enable rising or falling alarm
Example 50-2 Displays Configured RMON High Capacity Alarms
switch# show rmon hcalarms
High Capacity Alarm 10 is active, owned by Testuser
Monitors 1.3.6.1.2.1.31.1.1.1.6.16785408 every 300 second(s)
Taking absolute samples, last value was 0 (valuePositive)
Rising threshold low is 4294967295 & high is 15 (valuePositive)
Rising threshold assigned to event 1
Falling threshold low is 0 & high is 0 (valueNotAvailable)
Falling threshold assigned to event 0
On startup enable rising alarm
Number of Failed Attempts is 0
High capacity RMON alarms can be configured using the CISCO-HC-ALARM-MIB. See the
Note
MDS 9000 Family MIB Quick
Example 50-3 Displays Configured RMON Events
switch# show rmon events
Event 2 is active, owned by Test2
Description is CriticalErrors
Event firing causes log and trap to community eventtrap, last fired 0
Event 500 is active, owned by admin
Description is
Event firing causes log, last fired 138807208

Default Settings

Table 50-1
Cisco MDS 9000 Family CLI Configuration Guide
50-4
Example 50-1 and 50-3).
lists the default settings for all RMON features in any switch.
Reference.
Chapter 50 Configuring RMON
OL-18084-01, Cisco MDS NX-OS Release 4.x
Cisco