Displaying Fspf Interfaces; Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Displaying FSPF Interfaces

Example 26-9
•
•
•
•
•
•
•
Example 26-9 Displays FSPF Interface Information
switch# show fspf vsan 1 interface fc1/1
FSPF interface fc1/1 in VSAN 1
FSPF routing administrative state is active
Interface cost is 500
Timer intervals configured, Hello 20 s, Dead 80 s, Retransmit 5 s
FSPF State is FULL
Neighbor Domain Id is 0x0c(12), Neighbor Interface index is 0x0f100000
Statistics counters :
Default Settings
Table 26-4
Table 26-4
Parameters
FSPF
SPF computation
SPF hold time
Backbone region
Acknowledgment interval (RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
Hello interval
Dead interval
Distribution tree information
Cisco MDS 9000 Family CLI Configuration Guide
26-22
0x65(101) 0x00001094
displays the following information for each selected interface.
Link cost
Timer values
Neighbor's domain ID (if known)
Local interface number
Remote interface number (if known)
FSPF state of the interface
Interface counters
Number of packets received : LSU
Number of packets transmitted : LSU
Number of times inactivity timer expired for the interface = 0
lists the default settings for FSPF features.
Default FSPF Settings
Chapter 26 Configuring Fibre Channel Routing Services and Protocols
0x00001084
8 LSA 8 Hello 118
8 LSA 8
Default
Enabled on all E ports and TE ports.
Dynamic.
0.
0.
5 seconds.
30 minutes.
60 minutes.
20 seconds.
80 seconds.
Derived from the principal switch (root node).
1 500
Error packets 0
Hello 119 Retransmitted LSU 0
OL-18084-01, Cisco MDS NX-OS Release 4.x