Configuring Gigabit Ethernet High Availability; Vrrp For Iscsi And Fcip Services - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 45 Configuring IP Storage
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Gigabit Ethernet High Availability

Virtual Router Redundancy Protocol (VRRP) and Ethernet PortChannels are two Gigabit Ethernet
features that provide high availability for iSCSI and FCIP services.

VRRP for iSCSI and FCIP Services

VRRP provides a redundant alternate path to the Gigabit Ethernet port for iSCSI and FCIP services.
VRRP provides IP address failover protection to an alternate Gigabit Ethernet interface so the IP address
is always available (see
Figure 45-3
IPS module
IPS module
In Figure
members can be one or more of the following interfaces:
•
•
•
•
•
See the
You can configure no more than seven VRRP groups, both IPv4 and IPv6, on a Gigabit Ethernet
Note
interface, including the main interface and all subinterfaces.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Figure
VRRP Scenario
Switch 1
10.1.1.10
VRRP master
10.1.1.30
VRRP backup
Switch 2
45-3, all members of the VRRP group must be IP storage Gigabit Ethernet ports. VRRP group
One or more interfaces in the same IPS module or MPS-14/2 module
Interfaces across IPS modules or MPS-14/2 modules in one switch
Interfaces across IPS modules or MPS-14/2 modules in different switches
Gigabit Ethernet subinterfaces
Ethernet PortChannels and PortChannel subinterfaces
"Virtual Router Redundancy Protocol" section on page
45-3).
VRRP group
virtual IP 10.1.1.100
L2 switch
Cisco MDS 9000 Family CLI Configuration Guide
Configuring Gigabit Ethernet High Availability
Connect to
10.1.1.100
IP network
44-16.
45-5