Assigning Vsan Membership For Islb Initiators - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 2
switch(config)# islb save-initiator
name iqn.1987-02.com.cisco.initiator
switch(config)# islb save-initiator
10.10.100.11
switch(config)# iscsi save-initiator
ip-address 2001:0DB8:800:200C::417A
switch(config)# islb save-initiator
Step 3
switch(config)# exit
switch#
Step 4
switch# copy running-config
startup-config

Assigning VSAN Membership for iSLB Initiators

Individual iSLB hosts can be configured to be in a specific VSAN (similar to the DPVM feature for Fibre
Channel; see
interface VSAN membership.
Specifying the iSLB initiator VSAN is the same as for an iSCSI initiator. See the
Note
for iSCSI" section on page
To assign VSAN membership for iSLB initiators, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# islb initiator ip-address
10.1.1.3
switch(config-islb-init)#
Step 3
switch(config-islb-init)# vsan 3
switch(config-islb-init)# no vsan 3
When an iSLB initiator is configured in any other VSAN (other than VSAN 1, the default VSAN), for
Note
example VSAN 2, the initiator is automatically removed from VSAN 1. If you also want it to be present
in VSAN 1, you must explicitly configure the initiator in VSAN 1.
Cisco MDS 9000 Family CLI Configuration Guide
43-44
Chapter 22, "Creating Dynamic
43-17.
Purpose
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSLB initiator
whose name is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSLB initiator
whose IPv4 address is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSCSI initiator
whose IPv6 unicast address is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to all the iSLB initiators.
Returns to EXEC mode.
Saves the nWWN/pWWN mapping configuration
across system reboots.
VSANs"). The specified VSAN overrides the iSCSI
Purpose
Enters configuration mode.
Configures an iSLB initiator using its IPv4 address
and enters iSLB initiator configuration submode.
Assigns the iSLB initiator node to a specified VSAN.
Note You can assign this host to one or more
VSANs.
Removes the iSLB initiator from the specified
VSAN.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 43 Configuring iSCSI
"VSAN Membership