Configuring The Syslog-Based Alerts Using The Cli; Rmon-Based Alerts; Configuring Rmon Alerts Using The Cli - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 53 Configuring Call Home
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Call Home does not change the syslog message level in the message text. The syslog message texts in
Note
the Call Home log appear as they are described in the Cisco MDS 9000 Family System Messages Guide.

Configuring the Syslog-Based Alerts Using the CLI

To configure the syslog-group-port alert group, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# destination-profile
short-txt-destination alert-group
syslog-group-port
Step 4
switch(config-callhome)# destination-profile
short-txt-destination message-level 5

RMON-Based Alerts

You can configure the switch to send Call Home notifications corresponding to RMON alert triggers. All
RMON-based Call Home messages have their message level set to NOTIFY (2). The RMON alert group
is defined for all RMON-based Call Home alerts. To receive an RMON-based Call Home alert, you must
associate a destination profile with the RMON alert group.

Configuring RMON Alerts Using the CLI

To configure RMON alert groups, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# destination-profile
xml-destination alert-group rmon
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Enters Call Home configuration submode.
Configures the predefined destination profile
(short-txt-destination) to receive Call Home
Notifications corresponding to syslog messages
for the port facility.
Optional. Configures the predefined
destination-profile (short-txt-destination) to
send a Call Home message for syslog messages
whose severity levels map to Call Home
severity level of 5 or greater. The default is
message level 0 (all syslog messages).
Purpose
Enters configuration mode.
Enters Call Home configuration submode.
Optional. Configures a destination message
profile (rmon_group) to send Call Home
notifications for configured RMON messages.
Cisco MDS 9000 Family CLI Configuration Guide
RMON-Based Alerts
53-13