Configuring IVR
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Withdrawing an overlapping virtual domain from an IVR VSAN disrupts IVR traffic to and from that
Note
domain.
Use the ivr withdraw domain command in EXEC mode to temporarily withdraw the overlapping virtual
domain interfaces from the affected VSAN.
Only add IVR domains in the edge VSANs and not in transit VSANs.
Tip
Configuring IVR Virtual Domains
To configure an IVR virtual domain in a specified VSAN, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr virtual-fcdomain-add
vsan-ranges 1
switch(config)# no ivr virtual-fcdomain-add
vsan-ranges 1
To configure FCS with IVR virtual domains, configure the IVR virtual domains, discover the FCS virtual
Note
devices using the fcs virtual-device-add vsan-ranges command, and then activate the IVR zone set. For
more information, see the
Verifying the IVR Virtual Domain Configuration
View the status of the IVR virtual domain configuration using the show ivr
virtual-fcdomain-add-status command.
switch# show ivr virtual-fcdomain-add-status
IVR virtual domains are added to fcdomain list in VSANS: 1
(As well as to VSANs in interoperability mode 2 or 3)
Clearing the IVR fcdomain Database
You can clear the IVR fcdomain database by using the following command:
switch# clear ivr fcdomain database
Cisco MDS 9000 Family CLI Configuration Guide
23-24
"About FCS" section on page
Chapter 23
Configuring Inter-VSAN Routing
Purpose
Enters configuration mode.
Adds the IVR virtual domains in VSAN 1.
Reverts to the factory default of not adding IVR
virtual domains and removes the currently
active virtual domains for that VSAN from the
fcdomain manger list.
55-1.
OL-18084-01, Cisco MDS NX-OS Release 4.x