Using The Install Ssi Command - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 12 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
---
4
5
6
* this terminal session

Using the install ssi Command

You can use the install ssi command to update the boot image on an SSM. If the SSM is performing Fibre
Channel switching and no Intelligent Storage Services are provisioned on the module, this operation
does not disrupt traffic through the module. If the SSM is configured for Intelligent Storage Services, a
warning is displayed at the command prompt indicating that the operation will disrupt traffic and asking
if you wish to continue.
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must install the SSM
Note
on a Cisco MDS 9500 Series switch to update the EPLD. See the
page
To upgrade or downgrade the SSM boot image for Intelligent Storage Services, follow these steps:
Log into the switch through the console port, an SSH session, or a Telnet session.
Step 1
Step 2 Verify that the SSM is physically installed in the switch. If the module is not physically installed, insert
it into the desired slot. Issue a show module command to verify the status of the module.
switch# show module
Mod
---
4
5
6
...
Note the slot number for later reference.
Step 3 Verify the Cisco MDS NX-OS or SAN-OS release running on the switch and the location and name of
the SSI boot image on the switch following the procedure described in the
Image" section on page
Install the SSI image on the SSM.
Step 4
Note
switch# install ssi modflash://4-1/m9000-ek9-ssi-mz.2.1.2.bin module 4
OL-18084-01, Cisco MDS NX-OS Release 4.x
--------------------------------------
00-05-30-00-9e-b2 to 00-05-30-00-9e-b6
00-0e-38-c6-2c-6c to 00-0e-38-c6-2c-70
00-0f-34-94-4d-34 to 00-0f-34-94-4d-38
12-12.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
12-20.
As of Cisco SAN-OS Release 3.0(2), if the SSI boot image is located on bootflash: the install
ssi command copies the SSI boot image to the modflash: on the SSM.
Upgrading the SSI Boot Image
----------
JAB06480590
JAB082504MQ
JAB083407D3
"EPLD Configuration" section on
Model Status
DS-X9032-SSM ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
"Verifying the SSI Boot
Cisco MDS 9000 Family CLI Configuration Guide
12-25