FSPF Routes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
About Fibre Channel Routes
Each port implements forwarding logic, which forwards frames based on its FC ID. Using the FC ID for
the specified interface and domain, you can configure the specified route (for example FC ID 111211
and domain ID 3) in the switch with domain ID 1 (see
Figure 26-4
Domain ID 1
Note
Other than in VSANs, runtime checks are not performed on configured and suspended static routes.
Configuring Fibre Channel Routes
To configure a Fibre Channel route, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Cisco MDS 9000 Family CLI Configuration Guide
26-10
Fibre Channel Routes
fc1/1
Domain ID 3
FC ID 111211
Chapter 26
Configuring Fibre Channel Routing Services and Protocols
Figure
26-4).
Domain ID 7
Purpose
Enters configuration mode.
OL-18084-01, Cisco MDS NX-OS Release 4.x