Configuring A 48-Port 4-Gbps Fibre Channel Switching Module Example - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Example Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Enable the interfaces and return to configuration mode.
Step 6
switch(config-if)# no shutdown
switch(config-if)# exit
switch#

Configuring a 48-Port 4-Gbps Fibre Channel Switching Module Example

These steps describe how to configure the example shown in
Select interfaces fc 4/11 through fc 4/12.
Step 1
switch# config t
switch(config)# interface fc 4/11 - 12
Disable the interfaces and take them out of service.
Step 2
switch(config-if)# shutdown
switch(config-if)# out-of-service
Return to configuration mode.
Step 3
switch(config-if)# exit
switch#
Select the interfaces fc 4/1 through fc 4/6.
Step 4
switch# config t
switch(config)# interface fc 4/1 - 6
Configure the port speed, rate mode, and port mode on the interfaces.
Step 5
switch(config-if)# switchport speed auto max 2000
switch(config-if)# switchport rate-mode dedicated
switch(config-if)# switchport mode e
Step 6 Enable the interfaces and return to configuration mode.
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Select the interfaces fc 4/7 through fc 4/10.
Step 7
switch# config t
switch(config)# interface fc 4/7 - 10
Configure the port speed, rate mode, and port mode on the interfaces.
Step 8
switch(config-if)# switchport speed 1000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Enable the interfaces and return to configuration mode.
Step 9
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Cisco MDS 9000 Family CLI Configuration Guide
15-54
Chapter 15 Configuring Generation 2 and Generation 3 Switching Modules
Figure 15-7 on page 15-16:
OL-18084-01, Cisco MDS NX-OS Release 4.x