Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 536

Configuring SDV
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 21-6
To add the virtual device to a zone as a zone member, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# zoneset name zs1 vsan 1
Step 3
switch(config-zoneset)# zone name zone1
Step 4
switch(config-zoneset-zone)# member
device-alias vdev1
or
switch (config-zoneset-zone)# member pwwn
50:00:53:00:01:fa:70:09
Step 5
switch(config-zoneset-zone)# member pwwn
21:22:5:d8:15:11:8:8
Step 6
switch(config-zoneset-zone)# end
Step 7
switch# show zoneset
Step 8
switch# config t
Step 9
switch(config)# zoneset activate name zs1
vsan 1
Step 10
switch(config)# end
Step 11
switch# show zoneset active vsan 1
Cisco MDS 9000 Family CLI Configuration Guide
21-8
Zoning the Virtual Device with Real Devices
SAN Device Virtualization Zone
SAN Device
i1pwwn
Virtualization
vtpwwn
vt1
i2pwwn i3pwwn
i1 i2 i3
Virtual
Device
t1pwwn t2pwwn
t1 t2
Primary Secondary
Purpose
Enters configuration mode.
Groups zones under one zone set named zs1 in the
VSAN, vsan 1. Enters zone set submode.
Creates the zone zone1.
Adds a virtual device (vdev1) as device-alias type
zone member to the zone.
Alternatively, adds a virtual device as pWWN type
zone member to the zone.
Adds the real device to the zone.
Exits all modes.
Displays the zone sets configured for the VSAN,
vsan 1, in step 4, as well as the primary and
secondary pWWNs.
Enters configuration mode.
Activates the new zone, zs1 for the VSAN, vsan1.
Exits all modes.
Displays the active zone for the VSAN, vsan1.
Confirms the zone set and zone names.
Chapter 21 SAN Device Virtualization
OL-18084-01, Cisco MDS NX-OS Release 4.x