Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 410

Combining Generation 1, Generation 2, and Generation 3 Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The number of PortChannels allowed does not depend on the type of supervisor module. However,
Note
Generation 3 modules require the Supervisor 2 module on the MDS 9506 and 9509 switches.
The Generation1, Generation 2, and Generation 3 modules have the following restrictions for
PortChannel configuration:
•
•
•
Note Before adding a Generation 2 or Generation 3 interface to a PortChannel, use the show port-resources
module command to check for resource availability.
When configuring PortChannels on switches with Generation 1, Generation 2, and Generation 3
switching modules, follow one of these procedures:
•
•
When configuring PortChannels on switches with only Generation 2 and Generation 3 switching
modules, follow one of these procedures:
•
•
Table 15-19
Cisco MDS 9000 Family CLI Configuration Guide
15-26
Generation 1 switching module interfaces do not support auto speed with a maximum of 2 Gbps.
Generation 1 and Generation 2 module interfaces do not support auto speed with maximum of 4
Gbps.
Generation 2 and Generation 3 switching module interfaces cannot be forcefully added to a
PortChannel if sufficient resources are not available.
Configure the PortChannel, and then configure the Generation 2 and Generation 3 interfaces to auto
with a maximum of 2 Gbps.
Configure the Generation 1 switching modules followed by the Generation 2 switching modules, and
then the Generation 3 switching modules, and then configure the PortChannel.
Configure the PortChannel, and then configure the Generation 3 interfaces to auto with a maximum
of 4 Gbps.
Configure the Generation 2 switching modules, followed by the Generation 3 switching modules,
and then configure the PortChannel.
describes the results of adding a member to a PortChannel for various configurations.
Chapter 15 Configuring Generation 2 and Generation 3 Switching Modules
OL-18084-01, Cisco MDS NX-OS Release 4.x