C H A P T E R 46 Configuring Ipv4 For Gigabit Ethernet Interfaces; Configuring Interface Descriptions; Configuring Beacon Mode; Configuring Autonegotiation - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 46 Configuring IPv4 for Gigabit Ethernet Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•

Configuring Interface Descriptions

See the
description for any interface.

Configuring Beacon Mode

See the
interface.

Configuring Autonegotiation

By default, autonegotiation is enabled all Gigabit Ethernet interface. You can enable or disable
autonegotiation for a specified Gigabit Ethernet interface. When autonegotiation is enabled, the port
automatically detects the speed or pause method, and duplex of incoming signals based on the link
partner. You can also detect link up conditions using the autonegotiation feature.
To configure autonegotiation, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# interface gigabitethernet 2/2
switch(config-if)#
Step 3
switch(config-if)# switchport auto-negotiate
switch(config-if)# no switchport
auto-negotiate

Configuring the MTU Frame Size

You can configure the interfaces on a switch to transfer large (or jumbo) frames on a port. The default
IP maximum transmission unit (MTU) frame size is 1500 bytes for all Ethernet ports. By configuring
jumbo frames on a port, the MTU size can be increased up to 9000 bytes.
The minimum MTU size is 576 bytes.
Note
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring Beacon Mode, page 46-3
Configuring Autonegotiation, page 46-3
Configuring the MTU Frame Size, page 46-3
Configuring Promiscuous Mode, page 46-4
"About Interface Descriptions" section on page 13-17
"About Beacon Mode" section on page 13-19
Basic Gigabit Ethernet Configuration for IPv4
for details on configuring the switch port
for details on configuring the beacon mode for any
Purpose
Enters configuration mode.
Enters the interface configuration mode on the
Gigabit Ethernet interface (slot 2, port 2).
Enables autonegotiation for this Gigabit
Ethernet interface (default).
Disables autonegotiation for this Gigabit
Ethernet interface.
Cisco MDS 9000 Family CLI Configuration Guide
46-3