Supportshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

supportShow

supportShow
Displays switch information for debugging purposes.
Synopsis supportshow [[slotnumber/]portnumber1-portnumber2] [lines]
Description Use this command to display support information from groups of preselected Fabric OS and Linux
commands and other support and debugging information. You can specify the range of ports for
which to display this information. These commands are organized by groups, but note that the
order of the groups listed below is not the same as executed by the command.
SupportShow executes commands in the following command groups. Use supportShowCfgenable
or supportShowCfgDisable to modify the settings for each group.
os
exception
port
fabric
services
security
network
portlog
system
extend
filter
perfmon
ficon
iswitch
asic_db
iscsi
ag
crypto
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may
change without notice.
Operands This command has the following operands:
slotnumber
752
OS group commands, enabled by default.
Exception group commands, enabled by default.
Port group commands, enabled by default.
Fabric group commands, enabled by default.
Service group commands, enabled by default.
Security group commands, enabled by default.
Network group commands, enabled by default.
Portlog group commands, enabled by default.
System group commands, enabled by default.
Extend group commands, disabled by default.
Filter group commands, disabled by default.
Performance Monitor group commands, disabled by default.
FICON group commands, disabled by default.
FC Router group commands, disabled by default.
ASIC DB group commands, disabled by default.
iSCSI group commands, disabled by default.
Access Gateway group commands, disabled by default.
Encryption group commands, disabled by default.
On bladed systems only, specifies a slot number, followed by a slash (/).
Fabric OS Command Reference
53-1001186-01