Trackchangesset - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

trackChangesSet

trackChangesSet
Enables or disables the track-changes feature.
Synopsis trackchangesset [mode][, snmptrapmode]
Description This command enables or disables the track-changes feature. An SNMP-TRAP mode can also be
enabled. Trackable changes are:
•
•
•
•
•
•
The output from the track-changes feature is dumped to the error log for the switch. Use errDump
or errShow to view the error log.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
mode
snmptrapmode
Examples To enable the track-changes feature:
See Also snmpConfig, trackChangesHelp, trackChangesShow
798
Successful login
Unsuccessful login
Logout
Config file change from task
Track-changes on
Track-changes off
Specify 1 to enable the track-changes feature or 0 to disable the feature. The
default (if no operand is specified) is to disable the track-changes feature.
This operand is optional.
Specify 1 to enable errors to be sent to the SNMP-TRAP in addition to the
errlog or specify 0 to disable the SNMP-TRAP messages. The default (if no
operand is specified) is to disable SNMP-TRAP messages. This operand is
optional.
switch:admin> trackchangesset 1, 1
Committing configuration...done.
switch:admin> trackchangesshow
Track changes status: ON
Track changes generate SNMP-TRAP: YES
Fabric OS Command Reference
53-1001186-01