Porttestshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

portTestShow

Displays information from portTest.
Synopsis porttestshow [-ports itemlist]
Description Use this command to display a snapshot of information from portTest. The following information
displays:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operand:
-ports itemlist
Examples To display information from portTest:
See Also portLoopbackTest, portTest, spinFab, stopPortTest
Fabric OS Command Reference
53-1001186-01
Pass or fail information on a given port.
Port type tested.
Current state of portTest (NO TEST, TESTING, or TEST DONE).
Type of ports asked to test (ALL_PORTS, ALL_E_PORTS, ALL_L_PORTS, ALL_F_PORTS,
ALL_LB_PORTS, or SINGLE_PORT).
Pattern used in testing.
Seed used in testing.
User delay value.
Total iteration asked to test.
Current test iteration.
Total fails on this test.
Consecutive fails on this test.
portTest start time.
portTest stop time.
Timeout value.
Error code, if any.
Specify a list of user ports to test. By default, all user ports in the current slot
is assumed. Refer to the itemList help page for further details.
switch:admin> porttestshow 1
Port 1 : PASS
PortType: OTHER
PortInternalState: INIT
Pattern: 0x0
TotalIteration: 0
TotalFail: 0
StartTime: NONE
StopTime: NONE
Timeout: 0
PortState: NO TEST
PortTypeToTest: NO_TEST
Seed: 0x0
CurrentIteration: 0
ConsecutiveFail: 0
ErrorCode: 0
portTestShow
UserDelay: 0
2
663