Portcfgshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

portCfgShow

portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [[slot/]port]
portcfgshow option [slot/][ge]port [arguments] [optional arguments]
Description Use this command to display the current configuration of a port.
If no operand is specified, this command displays port configuration settings for all ports on a
switch, except gigabit Ethernet (GbE) ports. Additionally, use this command with optional
arguments to display specific FCIP parameters configured for a gigabit Ethernet port, such as the
following:
•
•
•
•
•
•
•
The following information is displayed when the command is issued for all ports or for a specific
port:
Speed
AL_PA Offset 13
Trunk Port
Long Distance
578
Address resolution protocol (ARP) entries
IP interfaces on the GbE port
Static routes on the IP interfaces
Fibre Channel over IP (FCIP) tunnel configuration settings
-
IKE and IPSec policy information
-
QoS mappings
Port Mode information
VLAN tag configuration
Inband Management IP addresses and routes configured on the Brocade 7500
Displays AN for auto speed negotiation mode, or a specific speed of 1, 2, 4, or
8 Gbps. This value is set by the portCfgSpeed command.
Displays (...) or OFF when the arbitrated loop physical address (AL_PA) on the
port is configured to use a 0x0 AL_PA address (default). Displays ON when
the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa
command.
Displays ON when port is set for trunking. Displays (..) or OFF when trunking is
disabled on the port. This value is set by the portCfgTrunkPort command.
Displays (..) or OFF when long distance mode is off; otherwise, displays long
distance levels as follows:
LE The link is up to 10 km.
LM The link is up to 25 km.
L1 The link is up to 50 km.
L2 The link is up to 100 km.
LD The distance is determined dynamically.
LS The distance is determined statically by user input.
This value is set by the portCfgLongDistance command.
Fabric OS Command Reference
53-1001186-01