Auditdump - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

auditDump

auditDump
Displays or clears the audit log.
Synopsis auditdump -s | -show
auditdump -c | -clear
Description Use this command to display or clear the audit log on the switch. The audit log persistently saves
the most recent 256 log entries on the switch. On modular platforms, the entries are not shared
across CPs. To display or clear the logs, this command must be issued for each CP separately.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-s | -show
-c | -clear
Examples To display the audit log:
To clear the audit log:
See Also auditCfg
44
Displays the audit log on the switch or the CP.
Clears the audit log on the switch or the CP.
switch:admin> auditdump -s
0 AUDIT, 2008/08/11-13:14:53 (UTC), [SULB-1003], INFO, FIRMWARE,
NONE/NONE/NONE/None/CLI, None/sw48000_100/FID CHASSIS, ,
Firmwarecommit has started.
1 AUDIT, 2008/08/11-13:16:12 (UTC), [SULB-1003], INFO, FIRMWARE,
NONE/NONE/NONE/None/CLI, None/sw48000_100/FID CHASSIS, ,
Firmwarecommit has started.
2 AUDIT, 2008/08/11-13:17:30 (UTC), [SULB-1003], INFO, FIRMWARE,
NONE/NONE/NONE/None/CLI, None/sw48000_100/FID CHASSIS, ,
Firmwarecommit has started.
[output truncated]
switch:admin> auditdump -C
Fabric OS Command Reference
53-1001186-01