Bpturboramtest - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

bpTurboRamTest

bpTurboRamTest
bpTurboRamTest - MBIST test for AP Blade BP ASICs.
Synopsis bpturboramtest [ -passcnt count ] [ -bpports itemlist ]
Description Use this command to verify the on-chip static random access memory (SRAM) located in the Blade
Processor (BP) ASICs of the Application Processor (AP) Blade. The command makes use of the
memory built-in self-test (MBIST) circuitry. The test flow for each SRAM is as follows:
1. Fill RAM with alternating FFFF 0000 pattern. (Subtest 1: turboram memory fill)
2. For each incrementing address read FFFF 0000 pattern and write 0000 FFFF. (Subtest 2:
3. For each incrementing address read 0000 FFFF pattern and write FFFF 0000. (Subtest 3:
4. For each decrementing address read FFFF 0000 pattern and write 0000 FFFF. (Subtest 4:
5. For each decrementing address read 0000 FFFF pattern and write FFFF 0000. (Subtest 5:
6. Repeat steps 1-5 with AAAA 5555 pattern.
Notes This command is currently supported only on the Brocade Encryption platform. It complements the
turboramTest, which tests the Condor2 ASIC on the switch.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-passcnt count
-bpports itemlist
Example To run the test in default mode:
SEE ALSO turboramtest
58
turboram r-m-w inc 1)
turboram r-m-w inc 2)
turboram r-m-w dec 1)
turboram r-m-w dec 2)
Specifies the number of test repetitions. By default the test runs once.
Specifies a list of blade ports to test. By default all blade ports in the
specified blade are tested. Note that on the Encryption platform, ports
80-103 are the blade ports connected to the BP ASICs. Refer to the itemlist
help page for further information on the itemlist parameter.
switch:admin> bpturboramtest
Running bpturboramtest ..............
Board Init
Running Vader bist test
Vader bist test PASSED
Running Ob1 bist test
Ob1 bist test PASSED
BIST test PASSED on all ASIC(s)
Test Complete: bpturboramtest Pass 1 of 1
Duration 0 hr, 1 min & 55 sec (0:1:55:884).
Cleaning up after test.......
passed.
Fabric OS Command Reference
53-1001186-01