Aliadd - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

aliAdd

Adds a member to a zone alias.
Synopsis aliadd "aliName", "member[; member...]"
Description Use this command to add one or more members to an existing zone alias. The alias member list
cannot contain another zone alias.
This command changes the defined configuration. For the change to become effective, enable the
zone configuration with the cfgEnable command. For the change to be preserved across switch
reboots, save the zone configuration to nonvolatile memory with cfgSave.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
Operands The following operands are required:
"aliName"
"member"
Examples To add members to zone aliases array1, array2, and loop1:
See Also aliDelete, aliRemove, aliShow
Fabric OS Command Reference
53-1001186-01
Specify the name of a zone alias, enclosed in double quotation marks.
Specify a member or list of members to be added to the alias, enclosed in
double quotation marks. Members must be separated by semicolons. An
alias member can be specified by one or more of the following methods:
•
A switch domain and port area or port index pair. Use switchShow for a
list of valid port area or port index numbers.
•
A world wide name (WWN).
switch:admin> aliadd "array1", "1,2"
switch:admin> aliadd "array2", "21:00:00:20:37:0c:72:51"
2
aliAdd
35