Nsshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

nsShow

Displays local Name Server (NS) information.
Synopsis nsshow [-r -t]
Description Use this command to display local NS information about devices connected to this switch. If no
information is available for the switch, the command displays the message:
in the Local Name Server."
Use nsAllShow to display NS information for all switches in the fabric.
Each line of output displays the following information:
Type
PID
COS
PortName
NodeName
TTL
SCR
Device type
Permanent Port Name
There might be additional lines if the device has registered any of the following information (the
switch automatically registers SCSI inquiry data for FCP target devices):
•
•
•
•
•
•
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-r
Fabric OS Command Reference
53-1001186-01
U for unknown, N for N_Port, NL for NL_Port.
24-bit Fibre Channel address.
List of classes of service supported by device.
Device port World Wide Name (WWN).
Device node WWN.
Time-to-live, in seconds, for cached entries or NA (not applicable) if the entry
is local. This displays if the -r option is specified.
State change registration of the device. This displays if the -r option is
specified.
Device type if -t is specified.
Physical N_Port or NL_Port WWN.
FC4s supported
IP address
IPA
Port and node symbolic names
Fabric Port Name. This is the WWN of the port on the switch to which the device is physically
connected.
Hard address or port IP address
Replaces the time-to-live (TTL) attribute output with state change registration
(SCR) information in the display. This value indicates what type of RSCN a
device registers to receive. Values include:
SCR=0 Reserved.
2
nsShow
"There is no entry
471