Cfgadd - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

cfgAdd

cfgAdd
Adds a member to a zone configuration.
Synopsis cfgadd "cfgName", "member[ ;member...]"
Description Use this command to add one or more members to an existing zone configuration.
This command changes the Defined Configuration. For the change to take effect, enable the
configuration with the cfgEnable command. For the change to be preserved across switch reboots,
save the configuration to nonvolatile memory with the cfgSave command.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
Operands The following operands are required:
"cfgName"
"member"
Examples To add two new zones to the configuration "Test_cfg":
See Also cfgClear, cfgCreate, cfgDelete, cfgDisable, cfgEnable, cfgRemove, cfgSave, cfgShow
64
Specify a name for the zone configuration, enclosed in double quotation
marks.
Specify a zone member or a list of zone members to be added to the
configuration. The list must be enclosed in quotation marks. Members must
be separated by semicolons.
switch:admin> cfgadd "Test_cfg", "greenzone; bluezone"
Fabric OS Command Reference
53-1001186-01