Fastboot - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

Brocade fabric os command reference manual v6.2.0 (53-1001186-01, april 2009)

Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:

Table of Contents

fastboot

Reboots the Control Processor (CP), bypassing Power-On Self-Tests (POST).

Use this command to immediately reboot the CP. This command is similar to reboot, but skips POST

when the system comes back up, reducing boot time significantly.

If POST was previously disabled using the diagDisablePost command, then fastboot is the same as

This command is not available on non-bladed systems except for the Brocade 4100 and 4900.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

To reboot the Control Processor without executing power-on self test (POST) on startup:

Table of Contents