Portcfg - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

portCfg

portCfg
Enables or disables a port's configuration.
Synopsis portcfg action [slot/][ge]port [-range] arguments
Description Use this command to manage configuration parameters for ports and gigabit Ethernet (GbE) ports.
The following operations can be performed with this command:
•
•
•
•
•
•
•
•
•
•
•
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Some of the features supported by this command may require a license.
The port mirror feature is not supported in Virtual Fabric mode.
For port configuration details and procedures, refer to the respective chapters in the Fabric OS
Administrator's Guide.
Operands This command supports the following port options:
slot
[ge]port
This command supports the following actions and associated arguments. If no operand is
specified, the command prints the usage.
arp
538
Optionally add and delete Address resolution protocol (ARP) entries. Flush ARP table.
Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.
-
Delete, reset, and modify QoS mappings on an existing tunnel.
-
Create or modify a tunnel with VLAN tagging and Class of Service (CoS).
-
Create or modify a tunnel with Tape read/write Pipelining enabled or disabled.
-
Create or modify a tunnel with Byte Streaming enabled or disabled.
Configure IP interfaces on the GbE port.
Configure static routes on the IP interface.
Manage registered state change notification (RSCN) suppression on the local port.
Configure a mirror port on the local port.
Configure the FC port for FC Fastwrite.
Modify VLAN Tagging configuration for FCIP.
Manage FICON emulation in an FCIP tunnel.
Configure FTRACE feature.
Configure IP addresses and routes for inband management interfaces.
For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
Specifies the number of the port to be configured, relative to its slot for
bladed systems. For GigE ports, the ports are numbered ge0 - ge1. Use the
switchShow command for a list of valid ports.
Optionally add entries to the address resolution protocol (ARP) table or delete
entries from ARP table. Flush entire table. The syntax for portcfg arp is as
follows:
Fabric OS Command Reference
53-1001186-01