Auditcfg - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

auditCfg

auditCfg
Modifies and displays the audit log filter configuration.
Synopsis auditcfg --class audit_class
auditcfg --enable |--disable
auditcfg --severity severity_level
auditcfg --show
Description Use this command to configure the audit logging and to display the audit log configuration. This
command allows you to set filters by configuring certain classes, to add or remove any of the
classes in the filter list, to set severity levels for audit messages, and to enable or disable audit
filters. Based on the configuration, certain classes are logged to syslog for auditing. Syslog
configuration is required for logging audit messages. Use the syslogdIpAdd command to add the
syslogd server IP address.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
--class
--severity
--enable
--disable
--show
Examples To configure the audit log filter, disable audit logging, and show the configuration:
42
Configures filters for a specified audit class. To add or remove any of the
classes in the filter list, re-issue the --class option.
audit_class Specifies the filters to be configured. Valid values are: 1-ZONE, 2-SECURITY,
3-CONFIGURATION, 4-FIRMWARE and 5-FABRIC filters. This operand is
required.
Sets audit severity level. When severity is set, only log messages of type
severity_level and higher are displayed.
severity_level Valid values are INFO, WARNING, ERROR, and CRITICAL. By default, all
messages are logged. This operand is required.
Enables all filters.
Disables all filters.
Displays the current configuration. This operand is optional.
switch:admin> auditcfg --class 2,3
Audit filter is configured.
switch:admin> auditcfg --disable
Audit filter is disabled.
Fabric OS Command Reference
53-1001186-01