Turboramtest - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

turboRamTest

turboRamTest
Performs a turbo SRAM test of ASIC chips.
Synopsis turboramtest [--slot slotnumber][-passcnt count]
Description This command verifies the on chip SRAM located using the turbo-RAM BIST circuitry. The BIST
controller is able to perform the SRAM write and read operation at a much faster rate than the PCI
operation.
This test is supported on all 4 G and 8 G platforms.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following optional operands:
--slot slotnumber
-passcnt count
Examples To run the SRAM test with two passes:
See Also none
808
Specifies the slot number on which the diagnostic operates. All blade ports in
the specified slot are tested. This operand is optional. The default value is 0
and operates on fixed port count products.
Specifies the number of times to perform this test. This operand is optional.
The default value is 1.
switch:admin> turboramtest -passcnt 2
Test Complete: turboramtest Pass 2 of 2
Duration 0 hr, 0 min & 1 sec (0:0:0:417).
passed.
Fabric OS Command Reference
53-1001186-01