Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 394

2
ipAddrSet
-ls FID
When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for
the following parameters:
-cp cp_number
-chassis
Examples Command line examples
To configure an IPv6 address and prefix on a standalone platform:
To configure an IPv6 address and prefix on a single CP of a chassis:
To delete any existing IPv6 address and prefix on CP0 on an enterprise-class platform:
366
-slot number On a chassis with a blade processor (BP), specifies the slot number. On
standalone platforms with a hidden BP, such as the AP76500, this parameter
is not accepted.
-ipv6 [-auto | -noauto]
Enables or disables stateless IPv6 auto configuration on a switch or chassis.
When auto configuration is enabled, the host automatically performs
configuration of IPv6 addresses and periodic non-disruptive re-configuration.
By default, auto configuration is disabled.
Specifies the logical fabric ID for which to configure an IPFC network
interface. The FID is a decimal number. A switch that is not in Virtual Fabric
mode uses the -ls parameter with FID 128 (the effective, single Logical Fabric
number on such switches) to set the IPv4 FC address.
Assigns a specified IPv4 FC address and prefix to the logical switch instance
--add
represented by the specified FID. This command replaces any existing FC
IPv4 address.
IPv4_address/prefix
Specifies the IPv4 address and prefix for the IPFC network interface. The
IP Address is represented by a dotted decimal number, followed by a
slash and a prefix. This operand is required with the --add option.
Deletes the IPv4 FC address and prefix from a logical switch.
--delete
-ls IFID Specifies the fabric ID that identifies the logical switch for which to delete
the FC IPv4 address and prefix. This operand is required when deleting a
FC IPv4 address from a logical switch. On a switch that is not in Virtual
Fabric mode, use the -ls parameter with FID 128 (the effective, single
Logical Fabric number on such switches) to delete the IPv4 FC address.
Specifies the managed entity as a CP. Valid values are:
0 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address,
1 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address,
Specifies the managed entity as the chassis.
switch:admin> ipaddrset -ipv6
switch:admin> ipaddrset -cp 0 -ipv6
switch:admin> ipaddrset cp 0 -ipv6
and host name of CP0.
and host name of CP1.
add fec0:60:69bc:60:260:69ff:fed0:107/64
--
add 1080::8:800:200C:417A/64
--
delete
--
Fabric OS Command Reference
53-1001186-01