Cfgdisable - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

cfgDisable

cfgDisable
Disables a zone configuration.
Synopsis cfgdisable
Description Use this command to disable the current zone configuration. The fabric returns to non-zoning
mode, in which all devices see each other.
This command ends and commits the current zoning transaction buffer to both volatile and
nonvolatile memory. If a transaction is open on a different switch in the fabric when this command
is run, the transaction on the other switch is automatically aborted. A message displays on the
other switches to indicate that the transaction was aborted.
If the default zone access mode is "No Access", then this command becomes cfgEnable
"d_efault_Cfg". Refer to defZone help for zone access configuration.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
Operands none
Examples To disable the current zone configuration:
See Also cfgClear, cfgEnable, cfgSave
68
switch:admin> cfgdisable
You are about to disable zoning configuration. This
action will disable any previous zoning configuration enabled.
Do you want to disable zoning configuration? (yes, y, no, n): [no] y
Fabric OS Command Reference
53-1001186-01