Shellflowcontroldisable - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

Brocade fabric os command reference manual v6.2.0 (53-1001186-01, april 2009)

Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:

Table of Contents

shellFlowControlDisable

Disables XON/XOFF flow control on the console serial port.

shellflowcontroldisable

Use this command to disable XON/XOFF flow control on the console serial port. Flow control is

disabled by default.

Because this command changes the flow control on the console serial port, it must be executed

from a session that is logged in from the console serial port. This command cannot run from a

Telnet session.

This setting is saved in the configuration database; therefore, it is persistent across reboots and

power cycles.

On dual-CP systems, a reboot on the standby CP is required for this command to take effect. No

action is required on the active CP.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

To disable flow control:

Table of Contents