Removing And Installing The System Cover; Removing The Server System Cover; Figure 24. Installing The Front Bezel - Intel SR1625UR - Server System - 0 MB RAM Service Manual

2. Push the bezel onto the front of the server system until it clicks into place.

Removing and Installing the System Cover

Removing the Server System Cover

The server system must be operated with the chassis cover in place to ensure proper
cooling. You will need to remove the top cover to add or replace components inside of the
server.
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
To remove the server system cover, follow these steps:
1. Remove the security screw if it is installed (see letter "A" in
2. While holding in the blue button at the top of the server system in (see letter "B" in
Figure
3. Insert your finger in the notch (see letter "D" in
upward to remove it.
®
Intel Server System SR1625UR Service Guide

Figure 24. Installing the Front Bezel

25), slide the top cover back until it stops (see letter "C" in
Figure 25).
Figure
Figure 25) and lift the cover
AF002846
25).
41