SAS/SATA Midplanes
The midplane serves as the primary interface between the server board, the hot-swap
backplane, and the control panel. Two midplanes are offered for this system:
•
Passive SATA/SAS
•
Active SAS/SAS RAID.
Passive Midplane
The passive midplane s used as an interconnect, routing drive control signals from either
the on-board SATA ports of the server board or SAS/SATA ports from an add-in card to
the hot-swap backplane. The following diagram show the location for each connector
found on the passive midplane.
A.
Power Connector
B.
Fan 6 Connector
C.
Fan 5 Connector
D.
SAS/SATA Connectors
E.
Bridge Board Connector
®
Intel
Server System SR1625UR Service Guide
C
B
D
A
J
Figure 15. Passive SATA/SAS Midplane Components
E
F
G
H
I
F.
Fan 4 Connector
G.
Fan 3 Connector
H.
Fan 1 Connector
I.
Fan 2 Connector
J.
Backplane Connector
AF000047
27