Removing And Installing The System Cover; Removing The System Cover; Figure 21. Installing The Front Bezel; Figure 22. Removing The System Cover - Intel R1000EP Series Service Manual

Removing and Installing the System Cover

Removing the System Cover

The server system must be operated with the system cover in place to ensure proper cooling. You will
need to remove the top cover to add or replace components inside of the server. Before removing the
top cover, power down the server and unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the four screws (see letter A).
5. Slide cover back and lift upward (see letter B).
®
Intel Server System R1000EP Service Guide

Figure 21. Installing the Front Bezel

Figure 22. Removing the System Cover

Server System Features
17