Removing And Installing The System Cover; Removing The System Cover; Installing The System Cover; Figure 22. Removing The System Cover - Intel Server System R1000GZ Service Manual

Hide thumbs Also See for Server System R1000GZ:

Table of Contents

Hardware Installations and Upgrades

Removing and Installing the System Cover

The server system must be operated with the system cover in place to ensure proper cooling. You will

need to remove the top cover to add or replace components inside of the server. Before removing the

top cover, power down the server and unplug all peripheral devices and the power cable(s).

Note: A non-skid surface or a stop behind the server system may be needed to prevent the server

system from slding on your work surface.

1. Observe the safety and ESD precautions at the beginning of this book.

2. Turn off all peripheral devices connected to the server. Turn off the server.

3. Disconnect the power cord.

4. Remove the four screws (see letter "A").

5. Slide cover back and lift upward (see letter "B").

Place system cover onto the chassis and slide forward to engage recessed edge at front of

cover (see letter "A").

Tighten the four screws (see letter "B").

®®

Intel

Server System R1000GZ/GL Service Guide

Table of Contents

Do you have a question about the Server System R1000GZ and is the answer not in the manual?

Server system r1000gl