Installing The Cisco Unified Ip Phone - Cisco 7911G - IP Phone VoIP Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Installing the Cisco Unified IP Phone

Note
Procedure
Connect the footstand to the
1.
back of the phone. See
Figure 3-1 and Figure
Connect the handset to the
2.
Handset port.
Connect the power supply
3.
to the Cisco DC Adapter
port (DC48V) .
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
You must connect the Cisco Unified IP Phone to the network and to a power
source before using it. See
overview of the procedures that follow.
Before you install a phone, even if it is new, upgrade the phone to the current
firmware image.
Before using external devices, read the
Cisco Unified IP Phone" section on page 3-8
information.
To install a Cisco Unified IP Phone, perform these steps:
Notes
—
3-2.
—
Optional. When connecting
phones powered by an external
power supply, you must connect
the power supply to the phone
before connecting the Ethernet
cable to the phone.
When disconnecting the phone,
you must disconnect the Ethernet
cable before disconnecting the
power supply.
Installing the Cisco Unified IP Phone
Figure 3-2, Figure 3-3, and
"Using External Devices with Your
for safety and performance
Reference
—
—
See the
Cisco Unified IP Phones 7906G
and 7911G" section on
page
Figure 3-4 for a graphical
"Providing Power to the
2-4.
3-9