Cisco 7911G - IP Phone VoIP Administration Manual page 185

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Step 4
Table 7-3 Status Messages on the Cisco Unified IP Phones 7906G and 7911G
Message
BootP server used
CFG file not found
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Select Status Messages.
To remove current status messages, press the Clear softkey.
To exit the Status Messages screen, press the Exit softkey.
Description
The phone obtained its IP
address from a BootP server
rather than from a DHCP
server.
The name-based and default
configuration file was not
found on the TFTP Server.
Possible Explanation and Action
None. This message is informational only.
The configuration file for a phone is created
when the phone is added to the Cisco Unified
Communications Manager database. If the
phone has not been added to the Cisco Unified
Communications Manager database, the
TFTP server generates a
response.
Phone is not registered with Cisco
•
Unified Communications Manager.
You must manually add the phone to
Cisco Unified Communications Manager
if you are not allowing phones to
auto-register. See the
with Cisco Unified Communications
Manager Administration" section on
page 2-16 for details.
If you are using DHCP, verify that the
•
DHCP server is pointing to the correct
TFTP server.
If you are using static IP addresses, check
•
configuration of the TFTP server. See the
"Network Configuration Menu" section
on page 4-7for details about assigning a
TFTP server.
Status Menu
Found
CFG File Not
""Adding Phones
7-5