Cisco 7911G - IP Phone VoIP Administration Manual page 52

Overview of Configuring and Installing Cisco Unified IP Phones
Table 1-7 Checklist for Installing the Cisco Unified IP Phones 7906G and 7911G (continued)
Task
Configure these network settings on
4.
the phone by choosing Settings >
Network Configuration.
Unlock the phone settings before
Note
making these changes from the
phone.
To enable DHCP:
Set DHCP Enabled to Yes.
a.
To use an alternate TFTP server,
b.
set Alternate TFTP Server to
Yes. Enter IP address for TFTP
Server 1.
To disable DHCP:
Set DHCP Enabled to No.
a.
Enter static IP address for
b.
phone.
Enter subnet mask.
c.
Enter default router IP addresses.
d.
Enter domain name where phone
e.
resides.
Set Alternate TFTP Server to Yes
f.
Enter IP address for TFTP
Server 1.
Set up security on the phone.
5.
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
1-34
Chapter 1
Purpose
Using DHCP—The IP address
is automatically assigned and
the Cisco Unified IP Phone is
directed to a TFTP Server.
Consult with the
Note
network administrator
if you need to assign
an alternative TFTP
server instead of using
the TFTP server
assigned by DHCP.
Without DHCP—You must
configure the IP address,
TFTP server, subnet mask,
domain name, and default
router locally on the phone.
Provides protection against
data tampering threats and
identity theft of phones.
An Overview of the Cisco Unified IP Phone
For More Information
See the "Configuring
Startup Network Settings"
section on page
See the "Network
Configuration Menu"
section on page
See the "Configuring
Security on the
Cisco Unified IP Phone"
section on page
3-17.
4-7.
3-17.
OL11954-01