Overview Of Configuring And Installing Cisco Unified Ip Phones; Configuring Cisco Unified Ip Phones In Cisco Unified Communications Manager - Cisco 7911G - IP Phone VoIP Administration Manual

Overview of Configuring and Installing Cisco Unified IP Phones

Overview of Configuring and Installing
Cisco Unified IP Phones
Configuring Cisco Unified IP Phones in Cisco Unified
Communications Manager
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
1-26
When deploying a new Unified Communications system, system administrators
and network administrators must complete several initial configuration tasks to
prepare the network for Unified Communications service. For information and a
checklist for setting up and configuring a complete Cisco Unified
Communications network, refer to the "System Configuration Overview" chapter
in the Cisco Unified Communications Manager System Guide.
After you have set up the Unified Communications system and configured
system-wide features in Cisco Unified Communications Manager, you can add IP
phones to the system.
The following topics provide an overview of procedures for adding
Cisco Unified IP Phones to your network:
Configuring Cisco Unified IP Phones in Cisco Unified Communications
•
Manager, page 1-26
Installing Cisco Unified IP Phones, page 1-32
•
To add phones to the Cisco Unified Communications Manager database, you can
use:
Auto-registration
•
Cisco Unified Communications Manager Administration
•
• Bulk Administration Tool (BAT)
BAT and the Tool for Auto-Registered Phones Support (TAPS)
•
For more information about these choices, see the
Cisco Unified Communications Manager Database" section on page
Chapter 1 An Overview of the Cisco Unified IP Phone
"Adding Phones to the
2-12.
OL11954-01