Adjusting Maintenance Reminders - Labconco Cell Logic A2 User Manual

To add a user's email to receive e-mail alerts from the cabinet:
•
Touch the
corner of Figure 6-9 to add an email
address.
•
Enter your e-mail address, touch [DONE].
To test the user's email:
•
Touch [SEND TEST]
paper airplane) next to the desired e-mail
address. (If all information is correctly
entered, a test email from the cabinet will
be sent.)
Once the SMTP Settings (for the cabinet's e-mail
address) have been correctly entered, and the
notification e-mail address (e-mail address for who is
receiving the notifications) has been correctly entered
and tested, the final step is to select the alerts to send
to each e-mail address. Follow these instructions to
select alerts:
1. Touch [EDIT ALERTS]
The Alert options are the same as detailed in Table 6-1 of this section. A pop-up
will display the alert options.
2. Select the desired alerts. Touch [OK].
To delete a user's email:
•
Touch the e-mail address to delete, it will highlight.
•
Touch the [DELETE]
screen (reference Figure 6-9).

Adjusting Maintenance Reminders

Touch [Maintenance]. The cabinet records the time the filters, LED lamps and UV lamp
(if applicable) are in use. These timers are used to automate reminders for the
replacement of consumable components at the intervals set by the user. The default
values for each reminder are shown in Figure 6-10 under 'Reminders'. The value next to
each adjustable time is the time remaining before a reminder alert.
Once the component time remaining reaches 0, a pop-up to replace that component will
appear. If the user selects
prompted to replace the component after an additional 4 hours of use. If the component
Plus icon at the lower right
(represented by the
(represented by the pencil) next to the email address.
icon shaped like a trash can in the bottom left corner of the
[REMIND ME LATER] on the pop-up, the user will be
55
Figure 6-9